Billion Electric Company BIPAC 7402 - Manual (Page 77)

3G / ADSL2+ (802.11g) (VPN) Firewall Router
Chapter 4: Configuration
76
PPTP Connection - LAN to LAN
Click Configuration/VPN/PPTP. Choose LAN to LAN from Connect Type drop-down menu.
Name: A given name of the connection.
Connection Type: Remote Access or LAN to LAN.
Type: Check Dial Out if you want your router to operate as a client (connecting to a remote VPN server,
e.g. your office server), check Dial In operates as a VPN server.
When configuring your router as a Client, enter the remote Server IP Address (or Domain
name) you wish to connect to.
When configuring your router as a server, enter the Private IP Address Assigned to Dial in
User address.
Peer Network IP: Enter Peer network IP address.
Netmask: Enter the subnet mask of peer network based on the Peer Network IP setting.
Username: If you are a Dial-Out user (client), enter the username provided by your Host. If you are a
Dial-In user (server), enter your own username.
Password: If you are a Dial-Out user (client), enter the password provided by the your Host. If you are a
Dial-In user (server), enter your own password.
Authentication Type: Default is Auto if you want the router to determine the authentication type to use,
or else manually specify CHAP (Challenge Handshake Authentication Protocol) or PAP (Password
Authentication Protocol) if you know which type the server is using (when acting as a client), or else the
authentication type you want clients connecting to you to use (when acting as a server). When using PAP,
the password is sent unencrypted, whilst CHAP encrypts the password before sending, and also allows
for challenges at different periods to ensure that the client has not been replaced by an intruder.
Data Encryption: Data sent over the VPN connection can be encrypted by an MPPE algorithm. Default
is Auto, so that this setting is negotiated when establishing a connection, or else you can manually
Enable or Disable encryption.
Key Length: The data can be encrypted by MPPE algorithm with 40 bits or 128 bits. Default is Auto, it is
negotiated when establishing a connection. 128 bit keys provide stronger encryption than 40 bit keys.
Mode: You may select Stateful or Stateless mode. The key will be changed every 256 packets when you
select Stateful mode. If you select Stateless mode, the key will be changed in each packet.
Active as default route: As the connection type is LAN to LAN, this function will become to disable.
Active: This function activates or deactivates the PPTP connection. Check Active checkbox if you want
the protocol of tunnel to be activated and vice versa.
Note: When the Active checkbox is checked, the function of Edit and Delete will not be available.