beautypg.com

AEG S84000KMX0 User Manual

Page 14

background image

Problem

Possible cause

Solution

The appliance is noisy

The appliance is not supported

properly

Check if the appliance stands sta-

ble (all the four feet should be on

the floor)

The appliance does not

operate. The lamp does

not operate.

The appliance is switched off.

Switch on the appliance.

The mains plug is not connected

to the mains socket correctly.

Connect the mains plug to the

mains socket correctly.

The appliance has no power.

There is no voltage in the mains

socket.

Connect a different electrical ap-

pliance to the mains socket.

Contact a qualified electrician.

The lamp does not work.

The lamp is in stand-by.

Close and open the door.

The lamp is defective.

Refer to "Replacing the lamp".

The compressor operates

continually.

The temperature is not set cor-

rectly.

Set a higher temperature.

The door is not closed correctly.

Refer to "Closing the door".

The door has been opened too

frequently.

Do not keep the door open longer

than necessary.

The product temperature is too

high.

Let the product temperature de-

crease to room temperature be-

fore storage.

The room temperature is too

high.

Decrease the room temperature.

The compressor does not

start immediately after

pressing the COOLMATIC

switch, or after changing

the temperature.

This is normal, no error has oc-

curred.

The compressor starts after a pe-

riod of time.

Water flows on the rear

plate of the refrigerator.

During the automatic defrosting

process, frost defrosts on the

rear plate.

This is correct.

Water flows into the re-

frigerator.

The water outlet is clogged.

Clean the water outlet.

Products prevent that water

flows into the water collector.

Make sure that products do not

touch the rear plate.

Temperature cannot be

set .

COOLMATIC function switched

on.

Switch off COOLMATIC manually,

or wait to set the temperature

until the function has reset auto-

matically. Refer to "COOLMATIC

function"..

The temperature in the

appliance is too low/high.

The temperature regulator is not

set correctly.

Set a higher/lower temperature.

14

What to do if…