Bosch MX25E - Manual (Page 9)

-9-
CONNECTING THE DUST EXTRACTION
ATTACHMENT
The optional dust extraction attachment (sold
separately) is only for use when sanding. It is
not designed for use when cutting or grinding.
Assemble and attach the parts of the dust
extraction as shown in figure 3.
1. Before mounting the dust extraction
attachment pieces, remove any accessory
that is attached to the tool.
2. Make sure that the dust extraction hood's
felt ring is undamaged and faces tightly
against the sanding plate. Replace a
damage felt ring immediately.
3. Attach the two parts of the dust extraction
tube to each other and to the dust extraction
hood.
4. Position the assembled dust extraction
attachment onto the tool over the accessory
attachment area.
5. Secure the assembled dust extraction tube
onto the tool using the retaining clip as
shown in figure 3.
6. Attach the rubber backing pad and sanding
sheet.
7. Place a vacuum hose or vacuum cleaner
hose adapter onto the dust extraction tube.
8. Connect the vacuum hose to a vacuum
cleaner.
The vacuum cleaner must be suitable for the
material being worked. When vacuuming dry
dust that is especially detrimental to health or
carcinogenic, use a vacuum cleaner that is
specifically intended for that purpose.
FELT RING
RETAINING
CLIP
VAC024
1-1/4”
OR
1-1/2” HOSE
FIG. 3
BOSCH
VACUUM
HOSE
DM 2610958399 10-10:DM 2610958399 10-10 10/5/10 10:55 AM Page 9