Buffalo Technology Buffalo AirStation WHR-HP-AG108 - Manual (Page 5)

AOSS
Does your wireless client support AOSS? If so, then configuring your wireless network
securely is very simple. To use AOSS, your router and client device should already be
installed and powered on.
A.
Push the AOSS button on the top of your router and hold it in for a few seconds.
The AOSS light will begin to flash.
B.
Push the AOSS button on your client. Hold it in for a few seconds.
That’s it! It will take about 30 seconds for the connection to complete. When it’s
finished, the AOSS light will glow a solid amber, without blinking. You now have a
secure network connection!
Notes: After pushing the first AOSS button, you have 2 minutes to press the second one.
If your client device is a PC card, CardBus, or USB adapter, its AOSS button will probably be in its Client
Manager Software. Check your client device’s AOSS manual for instructions on where to push or click
the AOSS button.
Find the information you need to connect non-AOSS
devices to your AOSS network from the System Info
page in your AirStation’s client utility.
Only one AOSS wireless client adapter can be
configured with the AOSS router at a time. AOSS
buttons must be pressed again to connect each
additional AOSS wireless client adapter.
If your client device doesn’t support AOSS, or if you
want to configure your client manually, turn to page 6.
Standalone
Client Device
PC card Client Manager
Software
Step 3: Configure Wireless Settings (with AOSS)