AEG MMR 4128 - Manual (Page 30)

English
30
Overview of the components
Front (Fig. 1)
1 LCD Display
2
Button (Play/pause)
3 MODE button
4
/ buttons (Scan forwards / backwards)
5 Cover USB /memory cards connection
6 VOL+/VOL- buttons (volume)
7 PRESET button
8 RPT/MEM button (Repeat/store)
9 Telescopic antenna
Rear view (Fig. 2)
10 ON/OFF switch
11 AUX IN connector
12 DC +5 V connector
13 USB +5 V connector
14 Battery compartment
Accessories (without illustration)
Power supply
Li-Ion battery (BL -5 C)
Installation
• Read the manual thoroughly before operating the de-
vice!
• Choose a suitable location for the device. Suitable loca-
tions are dry, even and antislip surfaces on which you may
operate the device easily.
• Make sure there is proper ventilation for the device!
• Remove, if necessary, the protection sheet from the
display.
Power supply (Adaptor)
• Insert the grid plug into a properly installed three prong
socket. Connect the device with the plug connector by
inserting its plug into the DC +5 V jack of the device.
• Make sure the grid voltage corresponds to the figures on
the rating plate.
CAUTION:
• Only use the supplied power adaptor for this device.
Do not use for other devices.
• Only use the original AC adapter. This adapter is
optimally attuned to the enclosed battery to charge
the battery in a gentle process. Any other adapter can
shorten the battery life or can damage it or the device.
NOTE:
Disconnect from mains power supply during longer periods
of non-use.
Battery Operation
You can optionally also operate the device with the enclosed
3.7 V Li-Ion battery.
1. Open the battery compartment (14) on the back.
2. Insert the enclosed battery. Mind the correct polarity
(indicated on the bottom of the battery case)!
3. Close the battery case.
4. If the device is not used for a longer period of time,
remove the battery from the device to prevent a “leaking
out” of battery acid.
CAUTION:
• Batteries must not be disposed of in the garbage.
Please bring used batteries to competent collection
centers or back to the dealer.
• Only replace the battery with a different battery of the
same type.
WARNING:
Never expose batteries to high temperatures or direct sun-
light or throw batteries into fire for
danger of explosion!
Charging the battery
Before you can operate the device with the battery, you need
to charge it first.
1. Insert the battery. (
see “Battery operation”)
2. Connect the device to a wall socket with the power adap-
tor. The control lamp on the power adapter lights up red
and the battery is being charged.
When the battery is fully charged, the control lamp on the
power adapter will change to green.
CAUTION:
Never leave the device unattended during the charging
process.
NOTE:
• You can also charge the battery through the USB con-
nector +5 V (13). Connect the device with a USB cable
to a running PC.
• The duration of the charging process depends on the
state of charge of the battery.
General operation
Switch the device on/off
• Switch the device on by setting the ON OFF switch on
the back of the device to ON.
• To switch off the device, set the ON OFF switch to OFF.
NOTE:
The device will always be reset to the factory default vol-
ume when it is turned on again.