AEG FP5200 - Manual (Page 24)

24
Getting started
GB
7. Assembling the blender: hold the
blender jug upwards and insert
the blade assembly. Turn the blade
assembly clockwise to fasten. Caution!
The blades are very sharp!
9. Close the lid and insert the measuring
cup in the filler hole. (The measuring
cup can be used to add ingredients
during operation.) Close the filler hole
immediately after, to avoid splashing.
Caution! When processing hot
liquids, see paragraph 10.
8. Lock the blender jug into position
on the motor housing. When the
arrow is aligned with the “Locked”
indicator, the jug is locked in position.
Put the ingredients in the jug. (Do not
exceed the maximum filling volume
of 1,2 litres)
10. Processing hot liquids: allow hot
liquids to cool down until lukewarm
before filling the blender jug. Fill
the blender jug half full and start
processing on low speed. The blender
jug can become very warm – take
care to protect your hands and to
ventilate steam out through the filler
hole. Always close the lid before use.
11. Start the blender by turning the
speed selector to required speed.
Start at low speed, then progress to
a higher speed if required. For using
the PULSE function turn the Speed
selector to position ”PULSE”.
12. Switch off the blender by turning
the speed selector to position “0”.
After mixing, turn the blender jug
counter-clockwise and remove.