AEG F88060VI0P - Manual (Page 19)

2. Filter (A) has two parts. To disassemble the
filter, pull them apart.
3. Fully clean the parts with water.
4. Put the two parts of the filter (A) together
and push. Make sure that they engage
correctly in each other.
5. Remove the filter (B).
6. Fully clean the filter (B) with water.
7. Put the filter (B) to its initial position.
Make sure that it engages correctly in the
two guides (C).
8. Put the filter (A) into position in filter (B).
Turn the filter (A) clockwise until it locks.
To clean the spray arms
Do not remove the spray arms.
If the holes in the spray arms become clogged, remove remaining parts of soil with a thin
pointed object.
To clean the external surfaces
Clean the external surfaces of the appliance and control panel with a moist soft cloth.
Only use neutral detergents.
Do not use abrasive products, abrasive cleaning pads or solvents (acetone).
WHAT TO DO IF…
The start of the appliance does not occur or it stops during operation.
First try to find a solution to the problem (refer to the table). If not, contact the service
centre.
With some malfunctions, the display shows an alarm code:
•
- The appliance does not fill with water
• - The appliance does not drain the water
• - The anti-flood device is on.
C
What to do if… 19