AEG SCN71800S0 - Manual (Page 18)

Problem Possible cause Solution
The compressor does
not start immediately
after pressing the
FROSTMATIC or
COOLMATIC button,
or after changing the
temperature. This is normal, no error has
occurred. The compressor starts after
a period of time.
Water flows on the
rear plate of the re-
frigerator. During the automatic de-
frosting process, frost de-
frosts on the rear plate. This is correct.
Water flows into the
refrigerator. The water outlet is clog-
ged. Clean the water outlet.
Products prevent that wa-
ter flows into the water
collector. Make sure that products do
not touch the rear plate.
Temperature cannot
be set . FROSTMATIC or COOL-
MATIC functions switched
on. Switch off FROSTMATIC or
COOLMATIC manually, or
wait to set the temperature
until the function has reset
automatically. Refer to
"FROSTMATIC or COOL-
MATIC function"..
The temperature in
the appliance is too
low/high. The temperature regulator
is not set correctly. Set a higher/lower temper-
ature.
The door is not closed cor-
rectly. Refer to "Closing the
door".
The product temperature
is too high. Let the product tempera-
ture decrease to room tem-
perature before storage.
Many products are stored
at the same time. Store less products at the
same time.
The temperature in
the refrigerator is too
high. There is no cold air circula-
tion in the appliance. Make sure that there is cold
air circulation in the appli-
ance.
The temperature in
the freezer is too
high. Products are too near to
each other. Store products so that
there is cold air circulation.
REPLACING THE LAMP
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service Cen-
ter.
CLOSING THE DOOR
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
18 www.aeg.com