American Panel HURRICHILL AP120BCF1300-3 - Manual (Page 19)

AP120BC1000-3/ AP120BCF1300-3 Manual
18
For YES, the display will show:
The printer baud rate should be left at 1200.
However, to make a change:
x. To change the baud rate, press or then
press .
1200 Blinks
y. To change the timing, press or then
press .
15 Blinks
z. To change to YES or NO, press or then
press .
NO Blinks
aa. To change to YES or NO, press or then
press .
NO Blinks
bb. To change to YES or NO, press or then
press .
NO Blinks
The display will show for 2 seconds:
Then the controller will go into “OFF” state.
NOTE: During programming key can be used to return to the previous screen (except at
the steps 1h, 1i and 3d, when it has different functions
INITIAL PROGRAMMING
COMPLETE
INITIAL PROGRAMMING
NAFEM COMMUNICATION
NO
INITIAL PROGRAMMING
RECIPES?
NO
INITIAL PROGRAMMING
PRINT DURING CYCLE
NO
INITIAL PROGRAMMING
PRINT & SAVE EVENTS
EVERY 15 MIN
INITIAL PROGRAMMING
PRINTER BAUDRATE
1200
).
key is used to confirm the settings and advance to the next screen.
At any time, to bring the controller to “OFF” state, just pres the (“ON/OFF”) button.