beautypg.com

English – AEG WS 9-125 User Manual

Page 15

background image

14

English

GB

Never lead the workpiece to the grinding disk with your hand.
Under extreme conditions (e.g. smooth-grinding metals with the arbour

and vulcanized fi bre grinding wheel), signifi cant contamination can build

up on the inside of the angle grinder. For safety reasons, in such conditions

the inside should be cleaned thoroughly of metal deposits and a motor

circuit-breaker must be connected in series. If the motor circuit-breaker

trips the machine must be sent for repair.
For accessories intended to be fi tted with threaded hole wheel,

ensure that the thread in the wheel is long enough to accept the

spindle length.
Use the safety guard from the accessories range when performing

out cutting work.

SPECIFIED CONDITIONS OF USE

The angle grinder may be used for cutting, grinding, sanding and

wire brushing a wide range of materials, such as metal or stone. If

you have any doubts, please refer to the instructions supplied by the

accessory manufacturer.
Do not use this product in any other way as stated for normal use.

MAINS CONNECTION

Connect only to single-phase AC current and only to the system

voltage indicated on the rating plate. It is also possible to connect

to sockets without an earthing contact as the design conforms to

safety class II.

EC-DECLARATION OF CONFORMITY

We declare under our sole responsibility that this product is in

conformity with the following standards or standardized documents.

EN 60745, EN 55014-1, EN 55014-2, EN 61000-3-2, EN 61000-3-3, in

accordance with the regulations 2006/42/EC, 2004/108/EC

Rainer Kumpf

Manager Product Development

Authorized to compile the technical fi le

Winnenden, 2010-11-17

MAINTENANCE

The ventilation slots of the machine must be kept clear at all times.
Do not let any metal parts enter the airing slots - danger of short

circuit!

Use only AEG accessories and spare parts. Should components need to

be replaced which have not been described, please contact one of our

AEG service agents (see our list of guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please state

the Article No. as well as the machine type printed on the label

and order the drawing at your local service agents or directly at:

AEG Elektrowerkzeuge, Max-Eyth-Straße 10, D-71364 Winnenden,

Germany.

SYMBOLS

Please read the instructions carefully before
starting the machine.

CAUTION! WARNING! DANGER!

Always wear goggles when using the machine.

Always disconnect the plug from the socket before
carrying out any work on the machine.

Accessory - Not included in standard equipment,
available as an accessory.

Do not dispose of electric tools together with
household waste material! In observance of
European Directive 2002/96/EC on waste electrical
and electronic equipment and its implementation
in accordance with national law, electric tools that
have reached the end of their life must be collected
separately and returned to an environmentally
compatible recycling facility.