AEG KE8404021M - Manual (Page 34)

45°
3. Close the door until it is at an angle
of approximately 45°.
4. Hold the door with one hand on
each side and pull it away from the
appliance at an upwards angle.
Put the door with the outer side
down on a soft and level surface
to prevent scratches.
5. At this time you can remove the in-
ner glass panels and clean them.
To install the door do the above steps in
the opposite sequence.
2
B
1
Removing and cleaning the door
glasses
The door has 2, 3 or 4 panels of
glass (the number depends on
the model).
CAUTION!
Rough handling of the glass, es-
pecially around the edges of the
front panel, can cause the glass
to break.
1. Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the clip
seal.
2. Pull the door trim to the front to re-
move it.
3. Hold the door glass panels on their
top edges one by one and pull
them upwards from the guide.
4. Clean the door glass panels.
To install the panels do the above
steps in the opposite sequence. In-
sert the smaller panel first, and then
the larger one.
14. WHAT TO DO IF…
WARNING!
Refer to the Safety chapters.
Problem Possible cause Remedy
The appliance does
not heat up. The appliance is deactiva-
ted. Activate the appliance.
34 www.aeg.com/au