AEG SWS98820L0 - Manual (Page 12)

Problem Possible cause Solution
Products prevent that wa-
ter flows into the water
collector. Make sure that products
do not touch the rear
plate.
Water flows on the
ground. The melting water outlet
does not flow in the evap-
orative tray above the
compressor. Attach the melting water
outlet to the evaporative
tray.
The temperature in
the appliance is too
low. The temperature regula-
tor is not set correctly. Set a higher temperature.
The temperature in
the appliance is too
high. The temperature regula-
tor is not set correctly. Set a lower temperature.
The door is not closed
correctly. Refer to "Closing the
door".
Many bottles are stored
at the same time. Store less bottles at the
same time.
There is no cold air circu-
lation in the appliance. Make sure that there is
cold air circulation in the
appliance.
dEMo appears on
the Display. The appliance is in dem-
onstration mode (dEMo) Keep pressed approxi-
mately 10sec the Alarm
button since a long sound
of buzzer is heard and the
Display shut off for a short
while: appliance start
works regularly.
Upper or lower
square is shown in
the temperature Dis-
play. An error has occurred in
measuring the tempera-
ture. Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not
be possible).
5.1 Replacing the lamp Wine
Cellar
Disconnect the mains plug from the
mains socket.
12 www.aeg.com