AEG X67453MD0 - Manual (Page 8)

OPERATING INSTRUCTIONS 8
HOOD OPTIONS IN SENSOR MODE
When operating in Sensor mode, the type of
hob being used has an influence. Two options
are available:
• Electric hob ;
• Gas hob
Initially it is set to electric hob. To change the
setting, proceed as follows:
• Turn the hood off using the hood on/off
button
• Press and hold the Sensor button for 8
seconds until the LED flashes as described:
• 4 flashes indicate selection of the electric
hob;
• 2 flashes indicate selection of the gas
hob;
• Remove power for 10 seconds and then
reconnect it.
The calibration procedure is carried out every
time the type of hob is changed.
Calibration procedure: every time the hood is
turned on or the type of hob is changed, the
sensor calibration procedure is run. During this
time the hood must not be used for cooking
or subjected to particularly intense smells, for
example solvents or detergents.
This process requires:
• 13 minutes if the electric hob has been
selected;
• 1 minute if the gas hob has been selected;
This phase is marked by flashing of the LED on
the sensor button, if it has been pressed.Do not
turn the motor on during calibration.
Warning: Do not spray directly on the grill
cleaning products but only clean with a cloth
soaked in detergent. Avoid cleaning the grill
alcohol or silicone products.