AEG S63300KDW0 - Manual (Page 16)

Problem Possible cause Solution
Water flows on the
ground. The melting water outlet
does not flow in the evap-
orative tray above the
compressor. Attach the melting water
outlet to the evaporative
tray.
The temperature in
the appliance is too
low/high. The temperature regulator
is not set correctly. Set a higher/lower temper-
ature.
If your appliance is still not working prop-
erly after making the above checks, con-
tact the After Sales Centre. You can find
the list at the end of this manual.
REPLACING THE CONTROL
UNIT
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the con-
trol unit. Contact your Service Center.
CLOSING THE DOOR
1. Clean the door gaskets.
2. If necessary, replace the defective
door gaskets. Contact the After Sales
Service.
16 www.aeg.com