beautypg.com

Installation, 1 replacing the lamp, 2 closing the door – AEG SKD81800F0 User Manual

Page 14: 1 positioning

background image

Problem

Possible cause

Solution

The temperature in
the freezer is too
high.

Products are too near to
each other.

Store products so that
there is cold air circulation.

There is too much
frost.

Food is not wrapped cor-
rectly.

Wrap the food correctly.

The door is not closed
correctly.

Refer to "Closing the
door".

The temperature regula-
tor is not set correctly.

Set a higher temperature.

Upper or lower
square is shown in
the temperature Dis-
play.

An error has occurred in
measuring the tempera-
ture.

Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not
be possible).

dEMo appears on
the Display.

The appliance is in dem-
onstration mode
(dEMo).

Keep pressed approxi-
mately 10 sec. the OK but-
ton since a long sound of
buzzer is heard and the
Display shut off for a short
while: appliance start
works regularly.

6.1 Replacing the lamp

The appliance is equipped with a long-
life LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service
Center.

6.2 Closing the door

1.

Clean the door gaskets.

2.

If necessary, adjust the door. Refer
to "Installation".

3.

If necessary, replace the defective
door gaskets. Contact the Service
Center.

7. INSTALLATION

7.1 Positioning

WARNING!
If you are discarding an old appli-
ance that has a lock or catch on
the door, you must ensure that it
is made unusable to prevent
young children being trapped in-
side.

The appliance shall have the
plug accessible after installation.

Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:

Cli-
mate
class

Ambient temperature

SN

+10°C to + 32°C

N

+16°C to + 32°C

ST

+16°C to + 38°C

14 www.aeg.com