7 cleaning the inlet hose and the valve filter, 8 frost precautions, Troubleshooting – AEG L61270BI User Manual
Page 21
12.7 Cleaning the inlet hose and the valve filter
1.
1
2
3
2.
3.
4.
45°
20°
12.8 Frost precautions
If the appliance is installed in an area
where the temperature can be less than
0° C, remove the remaining water from
the inlet hose and the drain pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Place the end of the emergency
emptying hose and that of the inlet
hose in a bowl placed on the floor
and let water flow out of the hoses.
4. Set the Drain programme and let it
operate until the end of the cycle.
5. Turn the programme knob to Off to
disconnect the appliance from the
power supply.
6. Screw the water inlet hose back on
and re-fit the emergency emptying
hose after having put the cap on
again.
WARNING!
Make sure that the
temperature is more than 0
°C before you use the
appliance again.
The manufacturer is not
responsible for damages
caused by low temperatures.
13. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
ENGLISH
21