AEG L61270WDBI - Manual (Page 9)

The display shows the following information:
Duration of the set programme
When you set a programme, the display shows the duration in hours and
minutes (for example 2.05).
The duration is calculated automatically on the maximum load for each
type of fabric.
After the programme has started, the time remaining is updated every mi-
nute.
Set drying time
When you set a drying programme, the display shows the drying time in
minutes and/or hours (see paragraph «Programmes for timed drying »).
After the programme has started, the appliance updates the remaining
time every minute.
Alarm codes
In the event of operating problems, some alarm codes can be displayed,
for example
(see chapter «Troubleshooting»).
End of programme
When the programme has finished, the display shows a blinking zero .
The Puerta bloqueada light C, the Lavado light A (or the Puerta bloqueada
light B) and the light of button Start/Pausa go out.
The door can be opened.
Incorrect option selection
If you set an option which is not compatible with the wash programme, the
display shows the message Err for some seconds.
The yellow pilot light of button Start/Pausa light starts blinking.
Delay Start
When you press the relevant button to set the delay (20 hours max), it ap-
pears for some seconds, then the display shows the duration of the set
programme.
The delay time value decreases by one unit every hour. When only 1 hour
remains, the time decreases every minute.
Delay Start symbol
This symbol comes on when you set the delay time.
Child safety lock
This symbol comes on when you activate the child lock function.
ENGLISH 9