AEG L61270WDBI User Manual

Page 26

Problem

Possible solution

The spin phase does not
operate or the washing
cycle lasts longer than
usually.

• Set the spin programme.
• Make sure that the drain filter is not clogged. Clean the fil-

ter, if necessary. Refer to 'Care and cleaning'.

• Adjust manually the items in the tub and start the spin

phase again. This problem may be caused by balance prob-
lems.

There is water on the
floor.

• Make sure that the couplings of the water hoses are tight

and there is not water leakages.

• Make sure that the drain hose have no damages.
• Make sure you use the correct detergent and the correct

quantity of it.

• Make sure you have replaced the emergency emptying cap

into the filter

• Make sure you have properly screwed the filter in after

cleaning.

You cannot open the ap-
pliance door.

• Make sure that the washing programme is finished.
• Set the drain or the spin programme if there is water in the

drum.

The appliance makes an
unusual noise.

• Make sure the levelling of the appliance is correct. Refer to

'Installation'.

• Make sure that the packaging and/or the transit bolts are

removed. Refer to 'Installation'.

• Add more laundry in the drum. The load may be too small.

The washing results are
not satisfactory.

• Increase the detergent quantity or use a different deter-

gent.

• Use special products to remove the stubborn stains before

you wash the laundry.

• Make sure that you set the correct temperature.
• Decrease the laundry load.

You cannot set an op-
tion.

• Make sure that you press only the wanted touch button(s).

The machine does not
dry or does not dry prop-
erly:

• Make sure that you have set a suitable drying programme

for your laundry.

• Make sure that you set the correct the drying time or dry-

ness degree.

• Make sure that the water tap is not turned on.
• the drain filter is not clogged.
• Make sure you have not overloaded the appliance.