7 cleaning the inlet hose and the valve filter, 8 frost precautions, Troubleshooting – AEG L61270WDBI User Manual

Page 24: 1 introduction

14.7 Cleaning the inlet hose and the valve filter

45°

20°

14.8 Frost precautions

If the appliance is installed in an area

where the temperature can be less than

0° C, remove the remaining water from

the inlet hose and the drain pump.
1. Disconnect the mains plug from the

mains socket.

2. Close the water tap.

3. Place the end of the emergency

emptying hose and that of the inlet

hose in a bowl placed on the floor

and let water flow out of the hoses.

4. Set the Drain programme and let it

operate until the end of the cycle.

5. Turn the programme knob to Off to

disconnect the appliance from the

power supply.

6. Screw the water inlet hose back on

and re-fit the emergency emptying

hose after having put the cap on

again.

WARNING!

Make sure that the

temperature is more than 0

°C before you use the

appliance again. The

manufacturer is not

responsible for damages

caused by low temperatures.

15. TROUBLESHOOTING

WARNING!

Refer to Safety chapters.

15.1 Introduction

The start of the appliance does not occur

or it stops during operation.