ADT Security Services 8112 - Manual (Page 8)

If there are bypassed points, AREA 1 ## BYPAS
(## = total number of bypassed points) is
displayed, followed by the point text descriptions
of the bypassed points. These displays scroll at the
rate of 2 seconds each. If there are no faulted or
bypassed points, the displays will not appear.
Instead, the display shows NO FAULTS/BYPAS.
3. The display returns to idle text after scrolling
through the faulted and bypassed point
information. You may also press ESC to stop the
display from scrolling.
To manually scroll faulted or bypassed points:
1. Ensure your command center shows idle text.
2. Press the NEXT key repeatedly to display the
faulted and bypassed point information. If there
are no faulted or bypassed points the displays will
not appear. Instead, the display shows NO
FAULTS/BYPAS.
3. You can return to idle text at any time by pressing
ESC.
View Faulted or Bypassed Points
To properly arm your system, all the doors and
windows in the system must be in the normal (not
faulted) condition. Viewing the faulted points helps you
find faulted points and correct them so proper arming is
possible.
Your command center offers two ways of displaying
faulted and bypassed point information. The first causes
the faulted or bypassed point information to scroll
automatically through the display. The second allows
you to manually scroll through each individual point
description.
To automatically scroll faulted or bypassed
points:
1. Ensure your command center shows idle text.
2. Press any number key. If there are faulted points,
AREA 1 ## FAULT (## = total number of faulted
points) is displayed first. This display is followed
by the point text descriptions of the faulted points.