Technical data, Closing the door – AEG AGN81800F0 User Manual
Page 31

Problem
Possible cause
Solution
The product temperature is too
high.
Let the product temperature de-
crease to room temperature be-
fore storage.
Many products are stored at the
same time.
Store less products at the same
time.
Products are too near to each
other.
Store products so that there is
cold air circulation.
Upper or lower square is
shown in the temperature
display.
An error has occurred in meas-
uring the temperature.
Call your service representative
(the cooling system will continue
to keep food products cold, but
temperature adjustment will not
be possible).
dEMo appears on the Dis-
play.
The appliance is in demonstra-
tion mode (dEMo).
Keep pressed approximately 10
sec. the OK button since a long
sound of buzzer is heard and the
Display shut off for a short while:
appliance start works regularly.
Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer to "Installation".
3.
If necessary, replace the defective door gaskets. Contact the Service Center.
TECHNICAL DATA
Dimension of the recess
Height
720 mm
Width
560 mm
Depth
550 mm
Rising Time
20 h
Voltage
230-240 V
Frequency
50 Hz
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.
Technical data
31