AEG S74010KDX0 - Manual (Page 14)

Problem Possible cause Solution
The appliance does
not operate. The appliance is switched
off. Switch on the appliance.
The mains plug is not
connected to the mains
socket correctly. Connect the mains plug to
the mains socket correctly.
The appliance has no
power. There is no volt-
age in the mains socket. Connect a another electri-
cal appliance to the mains
socket. Check fuse. Con-
tact a qualified electrician.
The lamp does not
work. The lamp is defective. Refer to "Replacing the
lamp".
The door has been open
to long. Close the door.
Door interferes with
ventilation grill. The appliance is not lev-
elled. Refer to "Levelling".
Misaligned door. The appliance is not lev-
elled. Refer to "Levelling".
As much as the advice does not lead to result, call the nearest brand-mark service.
6.1 Replacing the lamp
The appliance is equipped with a long-
life LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service
Center .
6.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
7. INSTALLATION
WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
7.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Cli-
mate
class Ambient temperature
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
14 www.aeg.com