Xerox WorkCentre M24-6075 - Manual

Fig. 2
At the Command prompt on the DOS screen type: “
telnet ” the IP
address of the SMTP server with port number “ 25 ”. Then press
Enter . The entry should display as in this figure.
Fig. 5
Type in “
mail from: your e-mail address ” and press Enter . The
entry should look something like this figure.
Fig. 1
Open a DOS Command Prompt window.
Note 1: This is a suggested testing procedure that requires
a working knowledge of DOS, and a program called
“Telnet .exe” or “Telnet.com”.
Note 2: If the echo function of your telnet program is not
enabled, you will not see what you type at the DOS
command prompt. Please type slowly and carefully.
Fig. 4
If you received the
ready message similar to the one in this figure,
continue to the next step.
Fig. 3
If you received a
Connect failed , repeat step Fig. 2 again. If it
continues to fail, please contact your IT Administrator or your Internet
Service Provider to obtain a working SMTP Server Address.
SMTP Server Verification - 1 of 2