Alliance Laundry Systems UW50P-4 - Manual (Page 27)

25 F232158 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Removal from Service
Decommissioning
In the event that the machine must be
decommissioned, follow these steps:
1. Clean interior of machine, both basket and shell.
a. Flush supply system with water.
b. Run a short rinse cycle to clean detergent and
chemical residues from the interior of the
machine.
2. Disconnect electrical power.
a. Shut off main power supply at the breaker box
or main control panel.
b. Have a qualified electrician disconnect power
to the machine at its source.
3. Disconnect hoses.
a. Disconnect drain hose from sump, gutter, or
drain.
b. Turn off water supply. Disconnect individual
hot and cold water inlet hoses from the
machine.
c. Allow time for residual water in the machine
to drain. Then disconnect drain hose from the
machine.
4. Disconnect steam hoses, if applicable.
a. Turn off steam supply and allow time for the
valves to cool.
b. Disconnect steam hoses from machine.
5. Remove the machine from its foundation pad.
a. Keep all panels in place to provide stability
when moving the machine.
b. Verify that door is closed and secure.
c. Loosen and remove the mounting bolts.
d. Break the grout seal at each corner of the
machine, using a crowbar.
e. Use crowbars at the front corners to lift the
machine a few inches so that the forks of a
forklift truck can reach under the machine.
f. Bolting the base frame to a pallet will
facilitate removal to a transport vehicle.
6. Recycle.
Alliance Laundry Systems uses the highest
quality materials in their products so that those
materials may be recycled at the end of the
product’s service life.