Xerox WorkCentre M118-M118i-15195 - Manual (Page 5)

Network Setup Using a Static IP Address
Xerox WorkCentre M118/M118i
3
Network Setup Using a Static IP Address
When the machine is powered on, it automatically uses DHCP to obtain its network configuration. To use a
static IP address, DHCP must be turned off and the IP address, gateway address, subnet mask, and
DNS Server address must be entered manually.
Pre-Requisites for Using a Static IP Address
Before you begin, obtain the following information from your network administrator:
Connecting the Machine Using a Static IP Address
1. Turn on the machine.
2. When the machine is Ready, press the Log In/Out button.
3. Press the Select button below the display to select System Settings .
a. Use the numeric keypad to enter the Password . The default password is 11111.
b. Press the Select button to select Confirm .
Turn DHCP Off
1. Press the Select button to highlight Print Settings , and then press the Enter button.
2. Press the the Enter button to select Network/Port .
3. Press the Select button until you see TCP/IP Settings on the display, and then press the Enter button.
4. Select Get IP Address , and then press the Enter button.
5. Select Manual , and then press the Enter button.
6. Press the Exit button.
IP Address: __________ . __________ . __________ . __________
Gateway Address: __________ . __________ . __________ . __________
Subnet Mask: __________ . __________ . __________ . __________
DNS Server Address: __________ . __________ . __________ . __________