Addtron Technology IP Power 9258 - Manual (Page 7)

_____________________________________________________________________________
IP POWER PAGE 13 OF 24
After changing the IP Power’s IP address, type the new address in the address field of your
web browser. You can also use the ipEdit.exe tool to locate the IP Power.
If the IP Power is connected to the Internet (WAN):
• IP Address: Enter the IP address provided by your ISP. If IP Power is
working with a router, please refer to the network settings of the router.
• Subnet Mask: Enter the Subnet Mask provided by your ISP. If the IP
Power is working with a router, please refer to the network settings of the
router.
• Default gateway: Enter the Default Gateway provided by your ISP. If the
IP Power is working with a router, please refer to the network settings of
the router.
• DNS Server: Enter the IP address of the DNS server provided by your
ISP.
• DHCP Client: Automatically obtain network settings from your ISP.
The IP address format is: xxx.xxx.xxx.xxx: yyyyy, where yyyyy means the port
number ranging from 1 to 32767.
Subnet Mask: from 0 to 254 ( xxx.xxx.xxx.0 ~ xxx.xxx.xxx.254)
If DHCP is disabled, you must set the TCP port and default gateway. If DHCP
is enabled, then the TCP port is preset to 80 (xxx.xxx.xxx.xxx:80) and the
default gateway will be assigned by the DHCP server.
If you specify a TCP port other than 80, enter it after the IP address of the IP
Power when accessing the IP Power control web pages, e.g.
http://xxx.xxx.xxx.xxx:yyyyy
NOTE
Beeper Setting: Enable – activate the beeper sounds. Disable – turn off beep
sounds.
When controlling the IP Power through the web pages, the beeper, if enabled, beeps
once to indicate an action has been successful.
HTTP Command Verification specifies the HTTP authentication for the IP Power to
use:
o Cookie +Base64 (allows HTTP command & SDK control)
o Cookie (allows HTTP command & SDK control)
_____________________________________________________________________________
IP POWER PAGE 14 OF 24
Email settings
The IP Power can be set to email its IP address 1 – 4 recipients.
Mail Server: The SMTP server for sending email. Please ensure that it is available.
POP3Server: The POP3 server.
Username: The SMTP username for sending email.
Password: The password for Username’s account. Note: the password can be no
longer than 8 characters.
Sender: The same of the sender to use. This will often be username@yourdomain.
Receiver 1 – 3: The email addresses to receive the IP Power’s IP address. They will
receive an email containing the IP Power’s IP address each time your log in to the IP
Power control web pages. Each receiver may be no more than 50 characters.
Subject: The subject of the mail, no more than 50 characters.
Mail Body: Type the content of the mail here, it must not be left blank.
Click Save to save your settings.