Konica Minolta bizhub PRO 2000P - Manual (Page 6)

6 Chapter 1 Safety information (GB)
Instructions for safe use
Instructions for safe use
Introduction
This product is designed with safety as an important feature and according to
international safety standards.
Read and follow these safety rules.
Safety rules
■
Do only maintenance procedures that are included in the User Manual.
■
Do not remove screws, hardware or covers, unless you are told to in the User
Manual.
■
Do not remove covers before the machine is disconnected from the main power
supply. Refer to the User Manual for the correct procedure.
■
Do not change fuses before the machine is disconnected from the main power
supply. Refer to the User Manual for the correct procedure.
■
Do not modify the machine. A modified machine is not safe to operate. The
product warranty is cancelled if you modify the machine.
■
Do not change or adjust the safety interlock switches fitted to the machine.
■
Do not use the machine if the machine makes unusual noises. Turn off the
machine. Disconnect the machine from the main power supply. Call your service
engineer.
Installation
■
Only an approved service engineer must install the machine.
■
Only connect the machine to a mains power supply of the correct voltage with a
good earth connection. The correct machine voltage is shown on the label at the
mains power supply input on the rear of the machine. If the machine is connected
to the wrong supply, the warranty is cancelled.
■
Make sure there is enough work area around the machine. Refer to the Site
Requirements document for the machine.
■
Install the machine on a level floor.
■
Use caution when you move the machine. The machine is heavy.
Trimmer Blade
This machine contains a power driven trimmer blade. When the machine is operated,
you must follow the safety rules in this document and in the User Manual.