AT&T 983 - Manual (Page 22)

19
Directory
Speed dialing
To store a number in speed dial
Press LINE 1 or LINE 2 to select a line, then
lift the handset, or press SPEAKER, or press
HEADSET (if a headset is connected).
Press and release
PROGRAM. There will be a
beep.
Enter the telephone number you want to store (up
to 24 digits) or press
(AUTO) REDIAL to store the
number last dialed. There will be a beep each time
you press a key. Press
PAUSE to include a dialing
delay.
Press and release the desired speed dial key to
store the telephone number in the upper location.
-
OR-
Press and release LOWER, then press the desired
speed dial key to store the telephone number
in the lower location. There will be a two-beep
confirmation tone.
5. Hang up. Press SPEAKER or HEADSET, or
replace the handset in the telephone base.
If there is a series of five beeps, an error was made.
Repeat steps 1-4 to store another number.
1.
2.
3.
4.
OPER
PQRS TUV WXYZ
ABC DEF
GHI JKL MNO
MIC
NOTES:
• You cannot store a pause as the first digit of a
memory number.
• If you take too long to program, there will be a
busy signal or operator recording of some kind.
Just ignore it and continue to program.