AT&T 983 - Manual (Page 11)

8
Getting started
Wall mounting
To return the bracket from the tabletop position to wall mounting, follow the
directions below.
A single two-line wall jack
If there is a single two-line wall jack, use only the black line cord. Install the
telephone as shown below:
NOTE: This product is designed to operate optimally with two telephone lines.
If you choose to install only one telephone line, the telephone will continue to
operate normally as long as the unused line is not selected. If you experience diffi-
culty, make sure you have pressed the correct LINE key.
3. Wind the line cord around the
hooks and on the bracket.
Thread the line cord through
the hole . Insert the line cord
into the groove as shown.
4. Press the bracket downwards until
it firmly clicks into place. Plug the
other end of the black line cord
firmly into the wall jack. Place the
telephone mounting holes and
just above the mounting studs,
then slide the telephone base down
until it is held securely.
5. When mounting the telephone on a
wall, you must reverse the handset
tab to hold the handset in place. Hold
down the switchhook, and slide the
tab up and out of its slot. Turn the
tab so that the end with the lip is up.
Insert the tab back into its slot.
1. Press the tab
as shown and
flip the bracket
t o w a r d s t h e
downward posi-
tion.
2. Plug one end of the
black line cord into
the jack labeled L1
or L1/L2 on the
back of the tele-
phone base. Insert
the line cord into
the groove.
Line 1 + Line 2