Konica Minolta magicolor 4750EN-4750DN - Manual (Page 184)

Network Connection 6-5
Setting the Address Manually
You may also manually change the printer’s IP address, subnet mask, and
gateway by using the following instructions. (See Chapter 5 “Understanding
the Ethernet Configuration Menus” for more information.)
"
When manually setting the IP address, turn off DHCP, BOOTP and
ARP/PING first. In addition, when the IP address is changed, add a
new port or reinstall the printer driver.
CAUTION
You should always notify your network’s administrator before changing
the printer’s IP address.
1
Turn on your PC and printer.
2
When the printer’s message window displays READY , set the IP address.
Press this
key . . . (until) the message window reads . . .
READY
PROOF/PRINT MENU
or if no optional hard disk kit HD-P03 is installed:
PRINT MENU
INTERFACE MENU
JOB TIMEOUT
ETHERNET
TCP/IP