Asus Motherboard NCL-DS - Manual (Page 34)

2 - 1 4 2 - 1 4 2 - 1 4 2 - 1 4 2 - 1 4 C h a p t e r 2 : H a r d w a r e i n f o r m a t i o n C h a p t e r 2 : H a r d w a r e i n f o r m a t i o n C h a p t e r 2 : H a r d w a r e i n f o r m a t i o n C h a p t e r 2 : H a r d w a r e i n f o r m a t i o n C h a p t e r 2 : H a r d w a r e i n f o r m a t i o n
Do not forget to connect the
CPU fan connector! Hardware
monitoring errors may occur if
you fail to plug this connector.
2. Use a Phillips screwdriver to
tighten the four heatsink screws
in a diagonal sequence.
3. Connect the fan cable to the
4-pin connector labeled
CPU_FAN1.
4. Repeat steps 1 to 3 to install
the other heatsink if you have
installed a second CPU, then
connect the fan cable to the
4-pin connector labeled
CPU_FAN2.
The heatsinks appear as shown
when installed.
CPU_FAN1
connector
CPU_FAN2
connector