Konica Minolta bizhub C451 - Manual (Page 43)

Troubleshooting 6
AU-101 42
If the problem is not corrected after the described operation is performed,
contact your technical representative.
The Add New Hardware
Wizard starts when this
device is connected to the
computer. Is this device connected
to the same USB port
used when the driver was
installed? If this device is connected
to a USB port different
from the one used when
the driver was installed,
the Add New Hardware
Wizard may start. Use the
same USB port used
when the driver was
installed.
Condition Possible cause Remedy