Konica Minolta KIP 7700 - Manual (Page 4)

KIP Restore/Ghosting Procedure
No part of this publication may be copied, reproduced or distributed in any form without express written permission
from KIP.  2012 KIP.
- 3 -
5. After several seconds the system attempts to boot from the
DVD. Pay attention to the screen at this time. Press a key on the
keyboard when the screen prompts “Press any key to boot from CD...” to start the restoring process.
The automated restore process is now started.
Note: Once this process is complete the Screen will become black
as it writes the Image from the DVD to the hard drive. This is done to
facilitate the internal restore capabilities of the KIP for any possible
later use.
6. When the IPS reboots the automated restore process is complete. Unplug the keyboard, and DVD
drive. Plug in the USB cables (from Step #1).
Note: Plug the USB cables into the same ports as you removed them from. Failure to do so will cause
system control issues!
7. The software will now automatically detect the printer model
Once the restore process is complete the install wizard will open guiding the technician through the
rest of the setup process.