Asus P5K64 WS - Manual (Page 133)

ASUS P5K64 WS 5-29
5.4.1 Installing Serial ATA hard disks
The motherboard supports Serial ATA hard disk drives. For optimal performance,
install identical drives of the same model and capacity when creating a disk array.
To install the SATA hard disks for a RAID configuration:
1. Install the SATA hard disks into the drive bays.
2. Connect the SATA signal cables.
3. Connect a SATA power cable to the power connector on each drive.
5.4.2 Intel ® RAID configurations
This motherboard supports RAID 0, RAID 1, RAID 5, RAID 10 and Intel ® Matrix
Storage configurations for Serial ATA hard disks drives through the Intel ® ICH9R
Southbridge chip.
See Chapter 4 for details on entering and navigating through the BIOS Setup.
Setting the RAID item in BIOS
You must set the RAID item in the BIOS Setup before you can create a RAID set(s).
To do this:
1. Enter the BIOS Setup during POST.
2. Go to the Main Menu, select SATA Configuration, then press .
3. Select the item Configure SATA as, then press to display the
configuration options.
4. Select RAID from the Configure SATA as item options, then press .
5. Select the item Onboard Serial-ATA BOOTROM, press , then select
Enabled from the options.
6. Save your changes, then exit the BIOS Setup.