Audiovox LCM1331FDW - Manual (Page 6)

Vehicle Preparation
1) Locate vehicle power source. Generally this is best found near the vehicle’s fuse block, which is usually (though not
always) under the steering wheel area. Locate an accessory hot circuit to tap into video system power. Accessory
hot means a circuit that is +12VDC when the ignition key is in either the “ACC’Y” or “Run” positions, and 0 volts DC
when the ignition key is removed from the vehicle.
2) Mounting location and method for the individual components will vary from vehicle to vehicle. This manual will only
focus on the installation of the video pod itself and related console accessories.
3) Generally, the best location for the video pod itself is where the vehicle’s dome light is traditionally installed (center of
roof, just behind the two front seats). The pod should NEVER be located in a position that would place it within the
driver’s field of view. This is not only hazardous for driving conditions (as it creates a distraction to the driver), but it is
against the law in many states. Check your state laws.
4) Once the pod location has been determined, there may be prep work required for the headliner. See mounting detail
below for headliner cutout dimensions and hole locations.
6
= Recommended Additional Cutout
= Minimum Cutout
5.05
0.85
0.62
10.65
11.99
12.55
1.44
TYP.
1.82
TYP.
0.40
TYP.
4.22
TYP.
Ø0.19
TYP.
0.57
TYP.
2.15
0.27
2.61
0.28
12.57
10.68
12.03