Antunes, AJ VS-200aSb - Manual (Page 12)

12
Variety SteaMer
P/N 1010649 Rev. E 03/07
DaIlY cleanInG
1. turn the Rocker switch (Power On/Off) to Off.
unplug the power cord and allow the unit to cool
down before proceeding.
2. check the rear water quick disconnect fitting and
all hose clamp connections for leakage. if leak-
age is apparent, tighten all clamps or replace
part(s) if necessary.
3. Remove the basket(s), top cover housing assem-
bly, and the drip tray, wash them in hot soapy
water, rinse and allow to air dry.
4. Remove the black Manifold Plate by slightly lifting
and sliding the Locking Lever (on the right side
of the unit) towards the rear, carefully remove
the plate and remove the large black O-ring from
the plate. Remove the diffuser plate, remove
the spray tube by carefully lifting the loose end
and gently twisting and pulling it out of the steam
generator hole. take a suitable 1/16” punching
tool (such as a large paperclip) and fully insert
it through all 12 orifices in the black mani-
fold as well as through the six orifices in the
spray tube. this will assure that the orifices are
not obstructed with debris. Wash all items in hot
soapy water, rinse, and allow them to air dry.
. Reinstall the spray tube into the steam generator
hole and reinstall the diffuser plate.
6. Lightly apply some Petro gel (supplied) onto the
large black O-ring and reinstall the O-ring onto
the manifold plate (this will allow the manifold
plate to seat easily onto the steam generator).
Hold the manifold plate up to a light and verify
that light is visible through all of the orifices. if so,
seat the manifold fully onto the generator and pull
the locking lever forward to lock the plate.
7. check that the Water Pressure Regulator is cor-
rectly set at 20-2 Psi (1.4 to 1.7 kg/cm2 or 138-
172 kPa.)
8. Reinstall all parts and accessories. Plug power
cord into electrical outlet.
maIntenance
warnInG
turn the unit off, disconnect the power source
and allow the unit to cool down before performing
any service or maintenance on the unit.
maintenance schedule
nOte: frequency of cleaning is determined by
water conditions, usage and water filter systems.
caUtIOn
Do not use a sanitizing solution or abrasive mate-
rials. the use of these may cause damage to the
stainless steel finish.
caUtIOn
If a chemical cleaner is used, be sure it is safe to
use on cast aluminum. Observe all precautions
and warnings on product label.
caUtIOn
Unplug power cord before moving and servicing
this appliance.
caUtIOn
failure to regularly and/or properly clean this
equipment may damage it or cause the user bodi-
ly injury
caUtIOn
chlories or phosphates in cleasnsing agents such
as bleach, sanitizers, degreasers, or detergents
could cause permanent damage to the sainless
steel equipmenet. the damage is ususally in the
form of discoloration, dulling of metal surface fin-
ish, pits, voids, holes, or cracks. this damage is
permanent and is not covered by warranty. the
following tips are recommended for maintenance
of your stainless steel equipment:
• always use a soft, damp cloth for cleaning,
rinse with clear water, and wipe dry. when
required, always rub in the direction of the
metal polish lines.
• routine cleaning should be done daily using
soap, ammonia detergent, and water.
• stains and sopts should be sponged using a
vinegar solution.
• finger marks and smears should be removed
using soap and water.
• Hard water spots should be sponged using a
vinegar solution.