Kodak S730 - Manual (Page 26)

24 www.kodak.com/go/digitalframesupport
Troubleshooting and support
Resetting the clock and calendar after losing power
If you turn off the power on the frame or otherwise lose power for longer than 12
hours, the clock and calendar return to the factory setting and the automatic on/off
times, if set, are disabled.
When you turn the frame back on, the Clock and Date screen appears.
1 Set the clock.
Tap the arrow lights or slide to select the current time (based on a 24-hour clock).
2 Set the date.
Tap the down arrow to highlight Year/Month/Day, then slide or tap between
the left/right arrow lights to select the current date (three separate settings).
3 Tap OK.
The time is reset and the automatic on/off times (if set) are re-enabled. It is not
necessary to reset the on/off times.
NOTE: If you exit the Clock and Date screen without setting the time, you can manually reset the clock and
re-enable the automatic on/off times ( see page 6 ). It is not necessary to reset the on/off times.
Cannot copy pictures
from one device
(memory card or USB
flash drive) to another
even though the copy
destination is not full. Storage devices that have FAT (File Allocation Table) 16 formatting can
only store up to 512 files in the top level (root) directory. To make sure
all your pictures copy properly, format the copy destination to FAT32
before copying to it:
CAUTION: Formatting deletes all pictures and videos,
including protected files.
1 Connect the device to your computer.
2 Open My Computer and locate the device.
3 Right-click on it and choose Format.
4 From the File system drop-down menu, choose FAT32 then click
Start.
If... Try one or more of the following