Picture quality problems – Kodak Z730 User Manual
Page 59
Troubleshooting
www.kodak.com/go/support
52
Picture quality problems
Slide Show does not run
on an external video
device
■
Adjust the camera Video Out setting (NTSC or PAL,
).
■
Make sure the external device settings are correct (see the
device’s user’s guide).
Status
Cause
The picture is too dark
or underexposed
■
Use Fill flash (
) or change your position so light is not
behind the subject.
■
Move so that the distance between you and the subject is within
the effective flash range (
).
■
To automatically set exposure and focus, press the Shutter button
halfway and hold. When the ready light glows green, press the
Shutter button the rest of the way down to take the picture.
■
Decrease the shutter speed or increase the ISO speed (
The picture is too light
■
Turn the flash off (
■
Move so that the distance between you and the subject is within
the effective flash range (see
■
To automatically set exposure and focus, press the Shutter button
halfway and hold. When the ready light glows green, press the
Shutter button the rest of the way down to take the picture.
■
Increase the shutter speed or decrease the ISO speed (
The picture is not clear
■
To automatically set exposure and focus, press the Shutter button
halfway and hold. When the ready light glows green, press the
Shutter button the rest of the way down to take the picture.
■
Clean the lens (
).
■
Make sure the camera is not in Close-up mode if you are more
than 23.7 in. (60 cm) from your subject.
■
Place the camera on a flat, steady surface or use a tripod.
Status
Cause