Kodak ESP 5 - Manual (Page 14)

14
www.kodak.com/go/aiosupport
Safety Information
- Read and follow these instructions before using KODAK products.
- Always follow basic safety procedures.
- Follow all warnings and instructions marked on the equipment.
WARNING STATEMENTS
- Do not expose this product to liquid, moisture, or extreme temperatures. KODAK AC adapters are intended for
indoor use only. The use of controls, adjustments, or procedures other than those specifi ed herein may result in
exposure to shock and/or electrical or mechanical hazards.
- Keep ink cartridges out of reach of children. Ink may be harmful if swallowed.
- Do not place your All-in-One Printer on an unstable cart, stand, bracket, or table. Injury to persons and damage to
the equipment may occur.
- The use of an accessory attachment that is not recommended by Kodak, such as an AC adapter, may cause fi re,
electric shock, or injury.
- Pushing objects through the equipment openings can result in an electric shock or risk of fi re.
CAUTIONARY STATEMENTS
- Adjust only those controls covered in the operating instructions.
- Do not disassemble this product; there are no user-serviceable parts inside. Refer servicing to qualifi ed
service personnel.
- The AC adapter power supply is equipped with 3-wire grounding type plugs. If you cannot insert the plug into the
power outlet, contact an electrician to check or replace the power outlet.
- Do not plug the AC adapter into a household extension cord.
- If the power cord or plug is frayed or damaged, the equipment gets wet, or the equipment does not operate
normally when the operating instructions are followed, unplug your All-in-One Printer from the power outlet and
contact Kodak qualifi ed service personnel for further instructions.
- For added protection from damage during a lightning storm, or any time when your All-in-One Printer and it’s
associated AC adapter will be left unused for long periods of time, unplug the AC adapter from the power outlet
and any attached fax line from the printer.
- To prevent your All-in-One printer from overheating do not place it near a heat register, or install it in a cabinet
without proper ventilation.
- Do not use your All-in-One Printer near water or spill liquid on it.
- Unplug the equipment from the wall outlet before cleaning.
- Dropping your All-in-One Printer may damage the housing and result in extensive damage that will require repair
by a qualifi ed technician to restore normal operation.
- Excessive dust levels may damage internal parts.
For more information, go to www.kodak.com/go/MSDS