Kodak Z5120 - Manual (Page 21)

www.kodak.com/go/Z5120support 21
7 Using an EYE-FI Card (optional
accessory)
This chapter pertains only if you’re using an EYE-FI Card.
An EYE-FI Card stores pictures just like an SD/SDHC Card does. It also
has a built-in Wi-Fi antenna that uses your Wi-Fi network to transfer
pictures from your camera to your computer or mobile device. Choose
an EYE-FI Card type X2 or higher.
To set up and use the EYE-FI Card and EYE-FI Center Software, follow
the EYE-FI documentation that accompanied the card.
CAUTION:
Before using an EYE-FI Card in this camera, it’s critical that
you disable (do not turn on) Endless Memory Mode in EYE-FI
Center Software.
1 Turn off the camera, then open the door.
2 Insert a card until it clicks into place.
To remove a card, press and release it.
NOTE: When you turn on the camera, it checks to see if a card is inserted. If
pictures/videos are detected in internal memory, the camera prompts you to move
them to the card. New pictures/videos are stored on the card.
Purchase EYE-FI cards www.eye.fi
Get support for EYE-FI Cards and Software support.eye.fi
urg_01328.book Page 21 Monday, October 24, 2011 9:23 AM