Kodak Li-Ion Battery Chargers - Manual

UK
1
2
3
4
5
6
EC
KODAK Essential Universal Li-Ion
Battery Charger UC-200
Battery Compatibility
Any rechargeable Li-Ion camera battery that will fit in the
charger either horizontally or vertically (oversized batteries),
and whose contacts engage the charger contacts, can be
charged.
LED Indicator
Flashing Green Charging.
Solid Green
Battery ready to use.
Flashing Red Charger error; let temperature normalize (see
Operating Temperatures)
Solid Red Battery error; replace battery.
Approximate Battery Charge Times
With 1000 mA @ 5 V input
Battery Charge Charge Time
mAh mA (Hours)
700 700 1.1
3.6 or 3.7 V 800 700 1.3
cells 1000 700 1.6
1200 700 1.9
7.2 or 7.4 V 1400 400 3.9
batteries 2000 400 5.5
2600 400 7.2
Specifications
Voltage:
Input— AC/DC Adapter: 100-240 V AC/50-60 Hz,
200 mA
DC Charger: 5V, up to 1000 mA
Output— AC/DC Adapter: 5.0 V, 1000 mA
DC Charger: 4.1 V, 700 mA; 8.2 V, 400 mA
Operating Temperatures:
32° F – 113° F (0° C – 45° C)
Charge Termination/Protection/Detection:
Maximum voltage; over and under temperature; current and
voltage set points; time controller.
IMPORTANT SAFETY INSTRUCTIONS—
Save these instructions
• DANGER—TO REDUCE THE RISK OF FIRE OR ELECTRICAL
SHOCK, CAREFULLY FOLLOW THESE INSTRUCTIONS.
• DANGER—CHARGE ONLY LI-ION BATTERIES SPECIFI-
CALLY MARKED AS RECHARGEABLE. OTHER TYPES OF
BATTERIES MAY LEAK, RUPTURE, OR EXPLODE AND
CAUSE PERSONAL INJURY AND DAMAGE.
Rechargeable Li-Ion batteries only.
• CAUTION: Keep dry. Do not use extension cords with this
product. Do not operate charger if it has been subjected to
electrical or physical shock or other damage. Do not
disassemble charger.
• The use of an accessory that is not recommended by Kodak
may cause fire, electric shock, or injury. For approved
accessories, visit www.kodak.com/go/accessories.
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
the use of the appliance by a person responsible for their
safety.
• Children should be supervised to ensure that they do not
play with the appliance.
• It is normal for batteries to become warm while charging.
• Use IEC 60950 certified ITE Power Supply.
EN
4H8720
FCC compliance and advisory
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed or used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures: 1) reorient or relocate the receiving
antenna; 2) increase the separation between the equipment and the
receiver; 3) connect the equipment to an outlet on a circuit different
from that to which the receiver is connected; 4) consult the dealer or an
experienced radio/TV technician for additional suggestions.
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment. Where shielded interface cables have been provided
with the product or specified additional components or accessories
elsewhere defined to be used with the installation of the product, they
must be used in order to ensure compliance with FCC regulation.
The USB AC adapter complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: 1) This device may not cause
harmful interference, and 2) this device must accept any interference
received, including interference that may cause undesired operation.
Canadian DOC statement
DOC Class B compliance—
This Class B digital apparatus complies wi th
Canadian ICES-003.
Observation des normes-Class B—Cet appareil numérique de la class e
B est conforme à la norme NMB-003 du Canada.
Made in China for
Eastman Kodak Company
Rochester, NY 14650 U.S.A.
©Eastman Kodak Company, 2011. MC/MR/TM: Kodak. 4H8720
www.kodak.com/go/accessories