Vogels PFW6850 - Manual (Page 3)

www.vogels.com 9531-006-Z00-02
1
3
2
44 3
2 1
Installation Guide
Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids
PFW6850
To ease the installation process you have the option to
remove the wide front plate and mounting brackets by simply
removing the three M5 x 10mm flat head screws, holding
the plate assembly to the swing out arm assembly and set-
ting them aside.
Take the thick cardboard mounting template supplied and
place the it over the mounting studs with the screen center
facing up. Confirm that the template is level horizontally and
that the wall place outline is to the center of your desired
height. Using a suitable stud-finder device for frame walls, mark the
position of the stud centers.
Measure the desired height of the center of the screen and
mark it.
Using a 1/4” drill bit, drill pilot holes minimum 2” (50mm)
deep into the four marked mounting points on the wall
surface. For solid concrete wall construction, the supplied
plastic wedge anchors are recommend to be used with the
5/16 x 3” lag bolt and washers supplied.
1/4” / 6.5mm
Wood Only