Vogels PFW6850 - Manual (Page 2)

www.vogels.com 9531-006-Z00-02
1/2”/14mm
M5 x 16mm M5 x 25mm M6 x 16mm M6 x 25mm M8 x 16mm M8 x 25mm 5/16” 5/16” x 3”
2.5mm
2.5mm
10mm
Template
M10 x 60mm 4mm
x4
x4
x4 x4 x4 x4 x4 x4 x4 x8 x4
1/4” / 6.5mm
(Wood Only)
3 4 A2 A1
Installation Guide
Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids
PFW6850
Remove the plastic hole covers from the upper and lower
plates. Loosen the (2) set screws on the plate using the
2.5mm allen key supplied. Reposition the upper and lower
pivot rods to mate to either the center or right side pivot
receiver holes, push the upper and lower plate fully on to the
rods, and re-tighten the set screws. Reinstall the side plate
with the eight flat head screws and confirm they are secure.
Reinstall the round plastic hole covers. Prior to initial step 1 of the installation, your PFW6850 can
easily have the main “swing left” pivot point of the main swing
out arm moved to either the center, left or right of the mount
by simply placing the mount on a flat surface and removing
the eight flat head screws, then separating the upper and
lower wall plates.
Included components
Required for installation
Pivot
Set Screw
Locations
Set Screw
Locations