Vogels PFW 6831 User Manual

Page 6

M16 Bolt

Display

Page 6

Installation Instructions

Lock Washer

Step 19. Locate Mounting Bracket A (Qty 2) and Mounting Bracket B (Qty 2).

Step 20. Locate the four (4) M16 hex head bolts and lock washers on the back of the display and remove them (place this hardwar

e to

the side as they will be used again).

Step 21. Align the mounting bracket holes on Mounting Bracket A with the mounting holes on the back of the display. Two

mounting holes will used on each side of the display.

Step 22. Place the lock washers between the display and the mounting brackets.

Step 23. Insert the M16 hex head bolts through the mounting bracket, then through the lock washer and into the display.

Step 24. Tighten the bolt and repeat Steps 20 and 21 for the remaining three bolts. Tighten all hardware.

DO NOT OVERTIGHTEN THE HARDWARE.

M16 Bolt

Lock Washer

Mounting

Bracket A

Clevis Pin

Clevis

Spring Clip

Step 25. Place Mounting Bracket B into Mounting Bracket A and

install the clevis pin, flat washer and clevis spring clip

hardware into the lower locations on the mounting

bracket.

Step 26. Repeat Step 25 for the remaining mounting bracket.

A - Mounting Bracket A

B - Mounting Bracket B

Flat Washer

PFW 6831