TotalPond PF1200UV User Manual

Page 6

12. Connect the UV clarifier plug into a properly grounded electrical

outlet. Fig. 12

Fig. 12

13. If using 3/4 in. ID tubing, proceed to step 14. If using 1 in. ID

tubing, cut the adapter as shown using a hacksaw. Fig. 13

Fig. 13

14. Connect a length of tube from the outlet of a pump to the inlet of

the filter (upper hole). Connect a length of tubing from the
outlet of the filter (lower hole) to a water feature. Fig. 14

NOTE: Pump and tubing is NOT INCLUDED. The adapter

is compatible with 1 in. or 3/4

in.

tubing.

Fig. 14

ASSEMBLY INSTRUCTIONS – Replacing the bulb

1. Disconnect the UV light from the outlet. Be sure to allow

sufficient time for the light to cool before disassembling the
light. Fig. 15

Fig. 15

GFCI

Cut ring

Out