Silent Call SK09214-2 User Manual

Page 9

10. Repeat the above steps ONLY if your other transmitters are set to a DIFFERENT address set-

ting than the transmitter you just programmed.

All erase:

Provisions are made to erase all programmed transmitter addresses. The ALL ERASE function is
performed as follows:

1. Turn off the Sidekick II Receiver by turning the AC power switch to the off position. Turn back-

up battery to off position (if you have the backup battery installed). An indication of power
being off would be that the blue and amber light on the strobe lens is off.

2. Press and hold the MINUTES pushbutton DO NOT RELEASE THE BUTTON

3. Turn the power back on while holding the MINUTES pushbutton in.

4. Once power is on, release the MINUTES pushbutton.

The all erase function is complete and the unit will now need to be re-programmed with its
transmitters.

technical Support

For technical support on this or any other Silent Call product, please feel free to contact us. You can
reach us by phone at 800-572-5227 (voice or TTY) or by Email at [email protected]

Limited Warranty

Your Silent Call product is warranted to be free of defects in material and workmanship for five
years from the date of initial purchase. During that time, the unit will be repaired or replaced free
of charge when shipped prepaid to Silent Call Communications. This warranty is void if the defect
is caused by customer abuse or neglect. We honor the smoke detector manufacturer’s warranty for
their smoke detector. Only Silent Call products are warranted for 5 years.