Silent Call SK09214-2 - Manual (Page 4)

4 5
2. Turn the Power ON at the ON/OFF SWITCH on the back of the receiver. The front panel
display will show the time 11:59AM. A blue light will be visible from the Strobe lens. The blue
light indicates that the unit’s AC power is on. An amber tone light will appear if the unit is in
battery backup mode. (If your unit is equipped with a battery back-up.)
3. Set Clock Time: Press and release the MODE pushbutton. The Orange LED will light up to let
you know that you are in “Set Clock Time” mode.
4. Press and release the minute button to set the minutes. Press and release the hour button to set
the hour.
5. When you are finished setting the minutes and hours, press and release the MODE pushbutton
three times to exit the Setup Mode.
NOte: Any time you unplug your Sidekick II Receiver from the wall outlet or turn the power off,
the next time you turn your Sidekick II Receiver on again, you will need to reset the clock. If you
are using the Battery Backup feature, you will not need to do this.
6. All of your Silent Call transmitters come pre-programmed from the factory to operate your
Sidekick II Receiver. If you need to set your transmitters to a different address, please refer to
the section in this manual on programming transmitters. The only reason you would need to do
this is if someone in your area is using Silent Call products and they are interfering with your
products.
Setting Alarm Clock:
1. Press and release the MODE push button twice.
2. The Green LED will light up indicating that you are in the “SET UP” mode. The display will
show the present Alarm Clock Time setting.
3. Press and release the MINUTES button to set minutes and press and release the HOURS button
to set the hours.
4. Once the Alarm Clock Time has been set, press the MODE button 2 times to exit the “SET UP”
mode.
5. When your alarm is activated the strobe light and bell icon will flash and the bed vibrator (op-
tional) will shake.