Audiovox Prestige 128-8111 - Manual (Page 3)

128-8111
3 of 20
T
o
exit program mode, turn ignition of
f, or press and release valet switch.
RF Programmable Features Bank 3 Is Remote Start Selectable Features: Feature Selection
1 Chirp
2 Chirps
3 Chirps
4 Chirps
5 Chirps
6 Chirps
1st Defrost Output
Not Available
2nd RF S
tart Chirp
Not Available
3rd Run Time
5
Mins
10 Mins
15 Mins
20 Mins
4th Parking Lights
On Steady
Flashing
5th Input Check
V
o
lt
a
g
e
T
ach
DBI Input
6th V
oltage Level
>0.5V B4 Start
< 0.5V B4 S
ta
rt
7th Ign. 2 Select
Off
During
Crank
On During Crank
Same As Accy
.
8th Ign. 3 Select
Not Available
9th Diagnostics
Off
On
10th Crank Time
0.8
Sec
1.0 Sec
1.5 Sec
2.0 Sec
1
1th Gas/Diesel
Gas
Diesel 10
Diesel 15
Diesel 20
12th Transponder O/P
While R/S On
During
S
ta
rt
Until Ign. Off
13th T
emp
S
ta
rt
Not Available
14th Crank
A
veraging
Averaging
Preset Time
Note:
When averaging, the engine must be started 4 times with the key to be effective.
15th R/S Shock
Not Available
16th Turbo Select
Not Available
17th Black/Blue (Aux O/P)
Single Pulse
As Feature #1Bank 2
Note: When setting feature #17 to operate as feature #1 Bank 1 the transmitter will also control this output only while running
under R/S command. So in
other words, if this output is used to unlock the doors with the transmitter
, the doors will unlock on st
artup.
T
o
re-lock th
e doors, use the
Af
ter S
tart Black
Green wire of the 4 pin connector
.
When using the RF programmer
, enter the program mode as follows:
Turn the ignition on Press and release valet switch 3 times turn ignition off then on Press and hold valet switch for 5 seconds Siren chirps 2 times indicating access to RF feature program mode. T
o
exit program mode, turn ignition of
f, or press and release valet switch.
3