Audiovox Platinum APS-597 - Manual

128-7407
1 of 12
Model APS-597
Installation Manual
SELECT
ABLE FEA
TURES
The selectable features can be set manually as explained below
, or with the RF feature programmer
.
T
o
set features using the RF programmer
, follow the instructions packaged with the programmer
.
Factory default settings are indicated by bold text. Note :
The method of manual override can either be selected to operate from the valet switch or operate as custom code.
Be certain to place a check mark indicating the method used in the box located on the last page of the owner's manual. NOTE: Keyless Entry Models with no horn output will Flash the Parking Lights instead of chirp where chirp is indicated. Also, No data will be indicated if a feature is not available for a particular model. The unit will enter the feature but no s
election will be available.
RF Programmable Feature Bank 1 Is For T
ransmitter Programming See T
ransmitter Programming Guide.
RF Programmable Features Bank 2 Is Alarm Selectable Features: Feature Selection
1 Chirp
2 Chirps
3 Chirps
4 Chirps
5 Chirps
6 Chirps
Default
1st DoorL/UL
1 Sec.
3.5 Sec.
1
Sec
L,
Dbl.
U/L
Dbl L, 1 Sec UL
Dbl
L,
Dbl
UL
1
S
l/350mS ul
1S/1S
2nd Accy Lock
Accy
Lock
On
Accy Lock Off
Auto Locks Off
3rd Accy
.
UL
Accy UL Dr
.
Accy
UL
All
Accy U/L Off
Auto UL Off
4th Headlights
O
n
A
rm
O
n
Disarm
On Both
O
ff
w/ Arm& Disarm
5th Passive Locks
Passive
Active
Active
6th Pass/Act Arm
Passive
Arm
Active Arm
Active
7th Siren/Horn
Siren/Horn
Siren Only
Horn Only
Siren/Horn
8th Horn Chirp
10mS
16mS
30mS
40mS
50mS
16mS
9th O/R Method
Custom Code
V
alet
V
alet
10th 2 Step U/L
O
n
Off
Off
1
1th Chp Del Tx
O
n
Off
Off
12th V
olts/HdW
ir
e
V
oltage Sense
Hardwire
Hardwire
13th Trigger Ckts
NA
14th L/UL Poll
N
A
When using the RF programmer
, enter the program mode as follows:
Turn the ignition on Press and release valet switch 3 times turn ignition off then on Press and hold valet switch for 5 seconds Siren chirps 2 times indicating RF feature program mode. Note:
Once you enter the feature programming mode, do not allow more than 15 seconds to pass between steps, or the programming will
be terminated.