Nostalgia Electrics CCP810 - Manual (Page 9)

E
N
G
LI
S
H
7
Assembly of Base Support
1. Push Handle (E) attaches onto the Concession Stand (C) using the four supplied #2 Bolts.
2. Insert Cross Bar (J) into the square inserts on the inside of Base Support (I) and secure from
below with two #1 Screws, two #4 Flat Washers and two #5 Spring Locking Washers. Insert
the Leg Assembly (K) into the square inserts between the ends of the Base Support (I) and
fasten from inside with two #2 Bolts, two #4 Flat Washers, two #3 Spring Locking Washers
and two #6 Nut Caps. Also secure from above with two #1 Screws and two #4 Flat Washers.
3. Assemble Base Support (I) into the bottom of the Concession Stand
(C) and secure with four #1 Screws and four #4 Flat Washers.
第4页 第4页
第3页
Assembly of Handles
Attach #7 Concession Stand Handle and parts using these directions:
HANDLE
HANDLE BRACKET
SCREW(12mm)
SCREWS(8mm)
DOOR PLATE